Axis-communications LBP 5200 Uživatelský manuál Strana 37

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 389
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 36
Connecting to a Computer
1-14
Before You Start Using This Printer
1
A USB cable is not supplied with this printer. Obtain a USB cable that matches the
computer you are using.
1
Plug the B-type (square) end of the USB cable into the USB
socket on the rear side of the printer.
2
Plug the A-type (flat) end of the USB cable into the USB port
on the computer.
NOTE
If the Plug and Play automatic setup feature of the computer displays a Wizard
after you connect the USB cable, install the printer software using one of the
following procedures. Refer to "Installing the CAPT Software," on p. 3-5 for more
details.
- Click [Cancel] and install the software from CD-ROM Setup.
- Install the software using Plug and Play.
If you are not sure about the USB cable that is supported by your computer, contact
the store where you purchased the computer.
Zobrazit stránku 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 388 389

Komentáře k této Příručce

Žádné komentáře